Winter Care Guide: Keeping Your Thermac Decontamination & Welfare Units Running Smoothly

Winter Care Guide: Keeping Your Thermac Decontamination & Welfare Units Running Smoothly

As temperatures drop, decontamination and welfare units can become vulnerable to some common cold-weather issues. Frozen boilers, burst pipes, and interrupted water supplies can quickly lead to costly repairs, downtime, and disruption on site. Fortunately, a few simple preventative measures can help keep your Thermac unit operational throughout the winter months.

Drain Down Your Boiler at the End of Each Day

One of the most important steps in protecting your welfare or decontamination unit during cold weather is ensuring the boiler is properly drained when the unit is not in use.

Whether you're leaving site overnight or completing the project altogether, make sure you locate the boiler's drain valve, which is typically found beneath the boiler itself. Open the valve to release any remaining water and leave it open until the unit is required again.

Taking a few minutes to complete this task can help prevent freezing and potential damage to the boiler system.

Don't Forget Showers and Sinks

It's not just the boiler that needs attention before temperatures fall overnight. Water left in shower units, wash stations, and sinks can easily freeze within the pipework during colder conditions.

Frozen pipes are one of the most common causes of winter callouts and can result in expensive repairs and avoidable delays on site. Draining all water systems at the end of each working day will significantly reduce the risk of frozen pipework and help maintain the reliability of your unit.

Check Your Utilities Before Problems Arise

Winter conditions can place additional demands on site welfare facilities. Before starting work, ensure you have an adequate supply of:

  • Gas
  • Water
  • Electricity

Running out of essential services during colder weather can quickly impact heating, hot water availability, and overall site welfare provision. Regular checks will help ensure your unit remains fully functional throughout the project.

Never Relight a Frozen Boiler

If you suspect your boiler has frozen, it is essential that you do not attempt to relight it.

Trying to ignite a frozen boiler can lead to further damage and may create additional operational issues. Always make sure the boiler has thawed completely before attempting to restart it.

If you're unsure whether your unit is safe to relight, contact the Thermac team first. Our experienced engineers can talk you through the correct procedure and help you avoid unnecessary repairs.

How to Deal with Frozen Pipes

Despite taking precautions, freezing temperatures can sometimes still cause pipework issues.

If pipes have frozen, allow them to thaw fully before use. A safe and effective method is to pour hot (but not boiling) water over the affected area to gradually defrost the pipework.

Avoid using boiling water, naked flames, or excessive heat, as these can damage pipes and fittings.

Expert Support When You Need It

Should you experience any issues with your decontamination or welfare unit, our experienced engineers can resolve the vast majority of problems directly on site.

Our support services include:

  • On-site repairs
  • Unit servicing
  • Electrical inspections and testing
  • Gas safety checks
  • Technical troubleshooting

In the unlikely event that a unit cannot be repaired on site, we can also provide a replacement hire unit to minimise disruption and keep your project moving.

Need Assistance?

Winter weather doesn't have to impact your site's welfare facilities. By following these simple preventative measures, you can protect your equipment, reduce downtime, and avoid unnecessary repair costs throughout the colder months.

For further advice or to arrange a service engineer visit:

📞 Call: 0800 018 2932
📧 Email: sales@thermac.com
🌐 Visit: thermac.com

Keeping your unit winter-ready today can save considerable time, cost, and disruption tomorrow.